POINTED ASSEMBLY ; page 27


Order of assembly

It is suggested that you assemble the cut parts initially with a few screws to check for location of parts, size/fit and alignment. When you are happy with the layout, dismantle and reassemble using water proof adheshive and corrosion resistant screws.
      (X) for numbers of the small beams [ X ] for numbers of boards

    The bottom

  1. To adjust (3) one the periphery of the bottom [ 1 ]
  2. To prepare [ 2 ] with (4)

    The channel

  3. to prepare [ 4 ] with (4)
  4. To prepare [ 6 ] and [ 8 ] with (3)
  5. To prepare [ 11 ] with (3) (left:cote ATTENTION and dimensions right)
  6. To set up [ 2 ] and the channel [ 4 ], [ 6 ] and [ 8 ]

    Element of dimension

  7. To prepare [ 9 ] and [ 10 ] and [ 11 ] with (3) on the high part
  8. To fix [ 9 ] and [ 10 ] and [ 11 ] out of (1)

    Sides

  9. To prepare [ 13 ], [ 14 ], [ 15 ], [ 16 ], [ 17 ], [ 18 ] with (2) leaving (2) extend beyond
  10. To fix the sides on (1) one by one and to adjust (2)

    Resin reinforcement

  11. Use woven glass fibre reinforcement tape and resin to reinforce all vertical and horizontal joints.
  12. Paint all the woodwork with fibreglass resin to give a durable and waterproof finish.

    Before bridging

  13. to reinforce all the liasions before closing of the case and installation of the buoyancy

    Buoyancy

  14. To set up the buoyancy
    to place foam STYRODUR panels in the case on 200 mm broad of the back has before (ATTENTION by respecting the air flow not to make a " wall ") It is possible to stop the channel by filling it of buoyancy

    Bridging

  15. to place [ 23 ], [ 24 ], [ 25 ], [ 26 ]
  16. to place [ 19 ], [ 20 ], [ 22 ] more [ 21 ] reinforcement in ep 8 in top of [ 20 ]
  17. painter face interior before joining

    Bail out

  18. to place [ 29 ], [ 28 ] and [ 30 ] use offcut of (3)

    Resin

  19. to reinforce all the liasion of bridging and the sides dimensions to return